Atech FL301 Rs485 Modbus Digital Water Flow Meter
The electromagnetic flowmeter adopts the volume flow measurement method, that is, the measurement is not sensitive to changes in fluid density, temperature, pressure, viscosity, etc. Once calibrated with water, the Sea Salt Irrigation Sewage Molasses Electromagnetic Flowmeter can be used to measure other types of conductive fluids - no additional calibration is required. This is a significant advantage not available in other types of flow meters.
Speifications
| |
| Converter | | Compact Type | IP65 | | Remote Type | IP65(IP68 optional) | | Measurement sensor | | Nominal Diameter | DN15-DN1000 | | Pressure rating
(High pressure can be customized) | DN6 - DN80, PN<4.0MPa | | | DN100 - DN150, PN<1.6MPa | | | DN200 – DN1000, PN<1.0MPa | | | DN1200 – DN2000, PN<0.6MPa | | Lining Material | Chloroprene rubber (CR),
Polytetrafluoroethylene (PTFE/F4),
Fluorinated ethylene propylene (FEP/F46),
Teflon(PFA) | | Electrode Material | 316L Stainless Steel, Hastelloy C, Hastelloy B, Ti, Ta, Pt | | IP Rate | IP68 | IP65 | | Medium temperature | -25 – 180℃ | -10 – 80℃ | | Serial communications | RS-485 | | | Output | Current (4-20 mA) , pulse , frequency , state switch | | Max measuring error | Measurement value ±0.5%(Flow speed > 1m/s)；
Measurement value ±0.5% ±2mm/s(Flow speed <1m/s) | | Repetitiveness | 0.15% | | Power supply | 100-240VAC,50/60Hz, 22VDC—26VDC | | Power consumption | Max 15VA | | Signal cable | Apply only to remote type | | Shielded cable | Signal section,wire: 0.5mm2 Cu /AWG20 | |
Main features
1. No moving assembly, no abrasion
2. Turn down ratio: 1:100
3. No flow lifting device
4. Applicable to various electronic conductive liquids
5. Not influenced by temperature, viscosity, pressure and density
6. Corrosion protection and self-diagnosis
7.Measure both to and reverse flow
8. Super large display, easy to operate
9. Long-term EEPROM, save data when power off
10. Support MODBUS/HART communication protocol
Installation Sketch
It should be installed at the lower part of the horizontal pipe and at the vertical upward position. Avoid installing at the highest point on the pipe and the vertical downward position
Install in the open discharge pipe, should beinstalled at the lower part of the pipe
Product Tags:
|
|
FL301 RS485 Modbus Electromagnetic Flow Meter Digital Water Flow Meter Images
|
